RESUN Water Change Automatically Set High-End
Automatic suction by creating a suction induced by the water jet of your faucet (even if the aquarium is higher than the sink), cleaning of the gravel by mulching.
Accidental sucking of fish or plants is not possible due to the built-in protective sieve in the Mulmglocke.
Safe use by simply ending the water change.
Closing the hose stopcock prevents further suction.
The previously built vacuum remains intact.
Simply open the stopcock again and the water will continue to flow out of the aquarium
. Once the desired amount of water has been drained from the aquarium, you can switch from aspirating to refilling at lightning speed.
Easy installation and handling:
Install the faucet connection, you may need to remove the perlator depending on the faucet model. The course of the direction sink shows should be closed initially.
Connect the head of the Mulm bell to the pipe. Connect the shorter hose to the other end of the trough vacuum. The Mulmglocke is not yet in the aquarium, just lay next to the aquarium!
Hook in the red / black stopcock on the edge of the pool and connect the hose with the mulching bell.
The stopcock must be closed! The long length of hose is connected to the opposite side of the closed stopcock.
Now lead this hose to the washbasin and connect it to the preassembled tap connection. When everything is firmly connected, open the drain that is directed towards the sink and turn the faucet on.
Now bring the Mulmglocke under water and open the stopcock. The flowing water of the faucet creates a negative pressure that sucks the water of the aquarium.
If the waste water has run completely through the hoses and runs off in the sink of the wash basin, close the stopcock on the edge of the basin. You can now turn off the tap.
Open the stopcock at the edge of the pool again and continue with the water change.
After vacuuming the refilling follows …
Now close again the stopcock on the edge of the pool. Also close the drain of the direction sink shows. Now open the faucet and then the stopcock on the edge of the pool. The basin fills with fresh, clean water.
If the pool is full enough, close the stopcock again and then the tap.
Hose Length: 15.2 meters
There are no reviews yet.